|
|
|
|
|
|
|
Looking For Bench Plans?
|
It can be free standing on the deck or the leg supports can be screwed to the deck. These bench plans will ensure your building success! Build your bench using the plan below or go to check out all the bench plans at U-Bild.com Material List
Step 1
Allow the Leg to Seat support to extend about 1 ¼” beyond opposite sides of the Legs. Attach the second Leg to Seat support to the other side of the Legs. |
Try
these classic bench plans for your deck benches. Here is one of my
basic bench plans for building a 6’ deck bench without a back.
Take
2 Legs, and space them ½” apart. Screw one of the Leg
to Seat supports perpendicular to the Legs and flush with the top
edge of the Legs.Step 2
Take those same legs and now attach the Deck mounting strips. Screw one of the 2x2s flush to the bottom edge of the Legs. Flip the Legs over and screw the other 2x2 to this side of the leg.
Step 3
Repeat steps 1 and 2 for the second set of legs.
Step 4
Position
the 2 sets of legs on the deck at about 56” apart (on center) in the
finished position. This will allow the bench seat to overhang the Seat supports
by about 8” on either side.
Step 5
Position the bench seat 2x4s on top of the Legs and Seat Supports. Push them together, eliminating any gaps or leaving only very small gaps.
Be
sure that the outside 2x4s do not extend beyond the ends of the Seat Supports.
Don’t worry about not leaving gaps. The boards will dry out and shrink
in about 1 to 2 months leaving a nice 1/8” to ¼” gap.
Screw the 2x4s (2 per board) into Seat Supports beneath them. The 2x4s should now be parallel with no gaps so you have a perfect 69”x14” bench seat.
Step 6
Take the 2x4s for the Seat Fascia sides and ends and cut each end at 45 degrees on a chop saw or miter saw for accuracy.
With
a friend helping, hold a Fascia side piece against the edge of the outside
2x4 board of the bench seat. Keep it flush with the top of the bench seat
and be sure to keep the inside edge of the mitered corner in line with the
end of the 2x4 bench seat board.
Screw one end of the Fascia into the edge of the 2x4 bench seat board. Now screw the other end in place.
Space more screws at about 12” apart.
Step 7
Repeat Step 6 for the other Fascia side piece on the opposite side of the bench. Then position the Fascia end pieces in between the side fascia.
They
should fit perfectly like a piece of a puzzle. Screw one screw through the
fascia end piece into each bench seat board and then two screws at each
miter corner securing the Fascia ends to the Fascia sides.
Congratulations! You now have a very nice looking bench for your deck.
Note: Steps 6 and 7 are the trickiest part of these bench plans and require attention to detail to get the miter cuts tight.
If you are not yet ready to build your own deck benches, let me share with you some information about other outdoor furniture tips and ideas that might help you out.
Home | Plans | Ideas | Railings | Benches | Stairs | Deck Building | Titan Post Anchor | Design Software | Deck Projects | Link To Us | Advertise | Contact | Shipping Info | Submit Article | About Us | What Is RSS?
Use
our concrete calculator for volumes of cement for deck footings or
our angle and unit conversion calculators. 
"Thanks again Richard for FedExing the other shipment of the Titan Anchors. They are installed, sturdy and look great. I am really happy with them here is a picture of the deck."
